• Registered: 2008-07-08
  • Posts: 172

Topic: Alesis multimix psu -- soldering help

So... i'm fixing my alesis mixer.  Somehow the three wires that connect to the power input became disconnected.

I cannot find a schematic for it online.. and the circuit board does not seem to have any labeling.  There are three wires that solder on to each pin.   

http://img.photobucket.com/albums/v625/alexalexalex/Picture1.png

The only labeling on this power input thing is: 3 2 1 (# next to each pin).

The wires are labeled with a V, a line, and some small print...      I'm guessing the V is the ground? and the one with the line is negative?  buhh

All i need to know is which wire to which # pin.......

can anybody help?

  • From: chroot
  • Registered: 2008-07-07
  • Posts: 680

Re: Alesis multimix psu -- soldering help

uuh god I remember those connectors... and I remember I had to resolder that as well tongue
but it was some years ago and for a different device, so I don't have pinout at hand...

but if I find it I'll post it.